Jewellers Bead and Grain Tools: A Guide to Sizes 0–18

A bead or grain tool is a small hand tool with a concave working end. In stone setting, that polished hollow is used to round a raised grain of metal or finish the top of a claw. Choosing the size begins with the metal you intend to shape, rather than the overall diameter of the stone.

Steel bead and grain tool, retouched representative range image
Steel bead and grain tool, retouched representative range image. Branding removed from the catalogue image.

One range, nineteen sizes

Our steel bead and grain tools are 60mm long and supplied individually. The range runs from size 0, stated as 0.25mm, to size 18, stated as 1.15mm. Each step adds 0.05mm. Use the table below to keep the size number and stated tip size together when ordering.

Size number Stated tip size Shop
0 0.25mm View size 0 tool
1 0.30mm View size 1 tool
2 0.35mm View size 2 tool
3 0.40mm View size 3 tool
4 0.45mm View size 4 tool
5 0.50mm View size 5 tool
6 0.55mm View size 6 tool
7 0.60mm View size 7 tool
8 0.65mm View size 8 tool
9 0.70mm View size 9 tool
10 0.75mm View size 10 tool
11 0.80mm View size 11 tool
12 0.85mm View size 12 tool
13 0.90mm View size 13 tool
14 0.95mm View size 14 tool
15 1.00mm View size 15 tool
16 1.05mm View size 16 tool
17 1.10mm View size 17 tool
18 1.15mm View size 18 tool

Each tool is £2.99 at publication. The range photograph is representative and is not a visual comparison of the nineteen tip sizes.

Illustrative jewellery workbench with a ring blank and bench peg
Illustrative jewellery workbench with a ring blank and bench peg. AI-created editorial illustration; accessories are not included.

Match the tool to the grain

The number on the listing identifies the tool size in this range. It is not a gemstone size, a drill diameter recommendation or a promise of a particular finished bead. Assess the grain or claw, the access around it and the result you want before selecting a tool.

For an unfamiliar setting, practise on a sample first. A useful comparison is to keep neighbouring sizes together and inspect the contact and result under magnification. Do not assume that more pressure will compensate for an unsuitable size or a damaged working end.

Illustrative loupe and ring blank on a jewellery bench
Illustrative loupe and ring blank on a jewellery bench. AI-created editorial illustration; accessories are not included.

Check the working end and holder

Inspect the polished concave end before use. Keep it clean and check that it has not been marked by contact with other tools. These are hand setting tools, distinct from rotary burrs and bead-stringing needles.

The catalogue tool is shown without a handle. A holder is not included, and its fit should be checked before use. Secure the work and use controlled hand pressure suited to the task. This guide is an introduction to the range, not a substitute for practical stone-setting tuition.

Illustrative divided drawers for storing small hand tools
Illustrative divided drawers for storing small hand tools. AI-created editorial illustration; accessories are not included.

Keep sizes organised

Store small tools separately so their working ends do not knock together. Keep each size with its label or a clearly identified compartment: the 0.05mm steps are too small to identify reliably from a general product photograph.

When replacing a favourite tool, record both its number and stated millimetre size. That makes repeat ordering clearer and avoids confusing a tool number with the dimensions of a stone.

Product image retouched to remove overlaid branding. Workshop scenes are AI-created editorial illustrations; they do not depict the supplied stock or an exact setting technique. One tool is supplied per listing, without the illustrated jewellery, holder or storage accessories.