Griffin Beading Wire: 19 and 49 Strand Size Guide

Beading wire is a flexible stringing material made from fine metal strands. Griffin’s clear nylon-coated stainless steel wire comes in 19- and 49-strand constructions. Choosing a reel means checking two separate specifications: the number of strands and the overall diameter.

Griffin 19 strand clear nylon-coated beading wire, 0.25mm, 30ft reel
Griffin 19 Strand Beading Wire — 0.25mm, 30ft

Strand count and diameter

The strand count describes the fine wires within the cable; the diameter describes its overall thickness. A 49-strand reel is not necessarily thicker than a 19-strand reel. Compare the stated millimetre measurement before choosing wire for a bead hole. Feel and drape also matter, so test the wire with the actual beads in your design.

Compare the available sizes

Each option below is a 30ft reel, approximately 9.15 metres, with a transparent nylon coating that leaves the steel colour visible.

Strands Diameter Length Product
19 0.25mm 30ft Shop this size
19 0.30mm 30ft Shop this size
19 0.35mm 30ft Shop this size
19 0.45mm 30ft Shop this size
19 0.53mm 30ft Shop this size
19 0.60mm 30ft Shop this size
49 0.30mm 30ft Shop this size
49 0.35mm 30ft Shop this size
49 0.45mm 30ft Shop this size
49 0.60mm 30ft Shop this size
Griffin 19 strand clear nylon-coated beading wire, 0.45mm, 30ft reel
Griffin 19 Strand Beading Wire — 0.45mm, 30ft

Check every bead hole

Start with the smallest hole, including spacers and any finding through which the wire must pass. Allow room for return passes at the clasp. Do not force wire through a tight or rough hole: check for sharp edges and test a short sample before committing the full length.

Plan the finish

Select crimps and other end fittings that are specified for your wire diameter and construction. Follow the component manufacturer’s instructions for the matching tool and technique. Leave enough working length to form a neat loop at the clasp without pulling the beads tightly together.

Griffin 49 strand clear nylon-coated beading wire, 0.30mm, 30ft reel
Griffin 49 Strand Beading Wire — 0.30mm, 30ft

Test the assembled piece

Check the drape before final finishing. Inspect and gently test each connection after crimping or securing the ends. The suitability of the finished piece depends on the beads, wire, findings and workmanship together; strand count alone is not a load rating.

Avoid kinks and damaged coating

Feed wire smoothly from the reel and avoid tight bends. Inspect any section that has been pinched or sharply folded. Replace damaged lengths instead of hiding a kink inside a bead.

Griffin 49 strand clear nylon-coated beading wire, 0.60mm, 30ft reel
Griffin 49 Strand Beading Wire — 0.60mm, 30ft

Keep spare wire organised

Store the remaining wire on its labelled reel so the strand count and diameter remain easy to identify. Keep it clean and dry, with the loose end secured without crushing the coating.