Leather Cord for Jewellery: Choosing Diameter, Colour and Fittings

Leather cord brings colour and a soft, flexible line to necklaces, bracelets and pendants. Choose the diameter around your beads and fittings first, then decide how the cord will be finished.

1.3mm or 2mm?

Our Griffin 1.3mm round cord is natural goatskin; the 2mm version is natural cowhide. Both are made in Germany and sold in 1-metre lengths. The finer cord suits designs that need a lighter line, provided it passes comfortably through the chosen components. The 2mm cord gives a more substantial appearance.

These are nominal diameters. Natural leather and individual fittings can vary, so test the actual combination before committing to a full design.

Lilac Purple round leather jewellery cord
Lilac Purple leather cord.

Match the cord to the smallest opening

Check bead holes, pendant bails and cord-end openings. Allow room for a second pass where your design needs one. A nominally matching hole can still be too tight; forcing leather through a rough or sharp opening may damage its surface.

Pink round leather jewellery cord
Pink leather cord.

Plan the finish before cutting

Lay out the necklace or bracelet at its intended finished length and allow extra cord for knots and end fittings. Test knots on an offcut, especially where they need to stop against a bead. For glued or crimped ends, follow the fitting and adhesive instructions and confirm compatibility with leather. Let adhesive cure fully before testing the assembly.

Each unit is a 1-metre length. Check the product listing when planning quantities; do not assume that several units will arrive as one continuous length.

Turquoise Blue round leather jewellery cord
Turquoise Blue leather cord.

Use colour deliberately

Try a close tonal match with a pendant, or choose a contrasting cord to make its outline stand out. Compare components together in daylight before final assembly. Natural leather may vary slightly between pieces, and photographs and screens can change how a shade appears.

Yellow round leather jewellery cord
Yellow leather cord.

Explore the available colours

2mm leather cord

1.3mm leather cord

Care for leather jewellery

Store spare cord loosely coiled, clean and dry, away from direct heat. Avoid soaking finished jewellery. Inspect the cord near knots, bails and clasps for wear, and replace damaged cord or insecure fittings before wearing the piece again.