Watch Stem Extenders: Matching the Stem and Crown Threads

A watch stem extender has two ends to match. Its female end screws onto the exposed thread of the winding stem. Its male end screws into the crown. Write the two sizes down in that order before choosing a part.

Read the thread pair from the stem towards the crown

For a stem with a 0.8 mm thread and a crown that accepts a 0.6 mm thread, select 0.8 mm to 0.6 mm. The two measurements describe thread sizes. Neither gives the length the extender adds.

Watchmaking workshop with benches and tools

Check both ends before ordering

Confirm the stem and crown thread specifications from the parts information for the repair. The outside diameter of the crown does not tell you its internal thread size. Check that enough sound thread remains on the stem for the extender to engage.

The watch winding stem extender is supplied singly. Its selector lists 29 female-to-male combinations across the 0.5–1.4 mm range. Choose the complete pair, including when both ends have the same size.

Watchmaker inspecting a timepiece

When the job calls for a complete stem

If the movement end of the stem is missing or damaged, identify the movement calibre and look up the complete replacement. An extender connects to the threaded portion that remains.

For Miyota calibres 2025, 2034 and 2035, the listed replacement is the Miyota 065.468 winding stem. The calibre reference identifies the replacement stem. Selecting an extender for a repair still requires the two thread sizes.

Watchmaker working on a pocket watch

For the ETA 803.xxx, 804.xxx and 805.xxx series, including 803.111, see the ETA 401 winding stem. Each replacement is sold as one stem.