Choosing Safety Chains, Brooch Backs and Chain Ends

Start with the part of the fastening that needs attention. A safety chain adds a second connection. A brooch back holds the brooch on the garment. A chain end gives the clasp a sound point of attachment. Identify that job before choosing the metal or size.

Safety chains for bracelets and necklaces

On a bracelet, check the distance between the attachment points with the main clasp closed, then check how far the bracelet needs to open to slip over the hand. On a necklace, a safety chain with its own clasp lets the wearer disconnect the secondary fastening when taking the necklace off.

Fine safety chain spanning the clasp of a yellow gold bracelet

Bracelet safety chains: Sterling Silver · 9ct Yellow Gold · 9ct Rose Gold · 9ct White Gold · 18ct Yellow Gold · 18ct White Gold. The 9ct white gold version measures 50mm long.

Necklace safety chains with clasps: Sterling Silver · 9ct Yellow Gold · 9ct White Gold · 18ct Yellow Gold · 18ct White Gold.

Choosing a brooch back or a secondary pin

A hook catch receives the tip of the brooch pin. A revolving catch closes around the tip. Measure the usable span on the reverse of the brooch and allow finger room at the catch. The sterling silver options are the 25mm revolving catch, 25mm hook catch and 30mm hook catch.

Rear of a brooch with its horizontal pin and catch visible

A brooch safety chain clips to the brooch and pins separately to the fabric. The sterling silver version measures 65mm. Choose from Sterling Silver · 9ct Yellow Gold · 18ct Yellow Gold · 18ct White Gold. The separate 9ct yellow gold safety pin is useful when just the garment pin needs replacing.

Measuring for a chain end

Lay the last link flat and measure across it in the position it will occupy in the fitting. Check the shape and depth of the opening as well as its width. For the silver caps below, the quoted width is measured across the widest part of the cap. Allow for the wall thickness when judging fit.

Chain ends and a necklace on the bench beside a measuring rule

Yellow gold chain ends for soldering: 3mm 9ct · 4mm 9ct · 5mm 9ct · 6mm 9ct · 8mm 9ct · 4mm 18ct.

Sterling silver flat end caps: 2mm (pack of 10) · 2.5mm (pack of 10) · 3mm (pack of 10) · 4mm (pack of 4) · 6mm (pack of 2) · 7mm (pack of 2). The 2mm and 2.5mm caps are both 5.5mm long. The 6mm and 7mm caps are both 8mm long.

Choosing the bolt ring at the chain end

Two rings matter when replacing a bolt-ring clasp. The spring-operated ring opens each time the necklace is worn. The smaller attachment ring joins the clasp to the chain. An open attachment ring can pass through a closed chain end. A closed attachment ring needs an opening connector at the chain end.

Compare the outer diameter with the original clasp, then check that the gate clears the fastening ring. Where two dimensions are given on a jumbo clasp, the second describes the width of its profile.

Rolled gold and gold plated

Platinum

Sterling silver

9ct gold

18ct gold